plastic lockers Fortress Lockers Systems™ 
 Our Plastic Lockers are Perfect for Pools, Athletic Clubs, Tropical Climate Areas, and more! 

olivegif.gif (811 bytes)

 plastic lockers   4 Easy Steps

 

 

 

 

Home

Home
Up

 

>Sub-pages for this topic:

Up

 

 

 

Back to Installation

lockers The following locker instructions are for "non-corner filled" rows.  

If you are installing corners without a professional installer, and need instructions: contact us at
800.683.2624 (or 410-224-2212) for info.

Step 1: Attach units to the wall or
back to back, only.

(Do not remove doors for installation.)

  • Attach units to the wall.  (level floor install)  starting from the corner out.  
    Warning: Do not attempt to adjust doors, attach handles or hasp before attaching lockers to the wall.
    Do not attempt to adjust doors, attach handles or hasp before attaching lockers to the wall.
    Warning: Do not leave lockers "free standing".   They must be attached either to the wall, or back to back. 
  • Holes have been pre-drilled in each unit (top left of 1st frame) and (top right of last frame).
    Mark hole placement on wall and drill.
    Make sure to use appropriate wall anchor (not provided) for your type of wall construction, and insert anchor into wall.
  • Place lockers next to one another in a tight configuration.  Fastening to the wall as you move down the row.
  • Irregular floors: (you will need to shim lockers before attaching to the wall).  Door adjustments will need to be made. 
    This type of install is not recommended for ideal results.
Step 2:   Attach handles.
(hardware provided)
  • Attach handles (2 screws per handle) with screwdriver.   (high-powered screw drivers not recommended)
Step 3: Attach the stainless steel hasp.  (hardware provided)

Skip this step if : you ordered any other type of locking mechanism.  All other lock types are pre-installed.

  • (Skip this step if: you ordered any other locking mechanism other than a hasp. All other locks arrive pre-installed.)
  • Attach stainless steel hasp.   Hasp is turned down inside locker, attached with one screw.  Simply turn the hasp up,  insert provided screw, and tighten!
Step 4:   Adjust doors.
  • Adjust doors. Hinges adjust 6 ways (up and down; left to right; in and out).  All lockers are adjusted on a 100% level platform before they are shipped.  Amount of adjustment will depend on the levelness of your facility floor.  Do not attempt any door adjustment UNTIL lockers have been attached to the wall, or back to back.

You are finished!  Simple, easy, fast ... and Beautiful! 
Enjoy your new Fortress Locker Systems™!
Back to Installation

Home ]
Sub pages for this page:
Up ]


 

aquagif1.jpg (633 bytes)

 

Home ]
Sub pages for this page:
Up ]

 

Email , or Call Us for more information on our plastic lockers and locker bench systems at: 1.800.683.2624 or 410.224.2212.
Fortress Locker Systems™   Annapolis, MD 21404  USA

All contents Copyright ©2008-1996  Fortress Lockers Systems™ / IHFS Inc. USA  All rights reserved.

Webmaster